Howrex System
For the production of glued and self part bind sets
When
there is a requirement to glue a two part set of bond paper, the
Inercote and Superflex process as described above is not applicable.
This is due to there being no middle sheet onto which Inercote can
be applied. This is why we have developed the Howrex system. Before
collation, either the top sheet or the bottom sheet of the set should
be fanned out on the bench into steps of 1/8th inch and Howrex release
agent applied, to either the top side of the first sheet or the
bottom side of the last sheet. The Howrex release agent effectively
repels the subsequent adhesive to allow separation to take place.
Howrex adhesive is then applied to the collated sheets. Once dry
the pad will fan apart into two part glued sets. The Howrex system
has numerous applications with difficult or unusual collations e.g.
CB, CFB etc. or sets of action paper. Howrex release agent is available
in aerosol spray, paste and grease to be applied by hand or dry
offset.
