Carrimount
Carrimount
- Will bond within 1 minute and has minimal fibre tear on the material when removed
Carrimount 848
- No fibre tear, but the surfaces will remain slightly tacky
Carrimount 525
- Latex adhesive, with no fibre tear and will allow the end-user to remove the residue off most surfaces
- Shelf life is limited to 6 months
Customers are advised to test all 3 adhesives to check the material being bonded, LEAVE FOR 24 HOURS / OVERNIGHT and THEN, assess the amount of tear, and if acceptable to the end-user. To reduce any fibre tear, we recommend, "sealing" the printed sheet and the card to be removed. The adhesives should be applied with a small dot using a Pafra 60 Pen or similar applicator.
Glue Dots on a roll
- Simply press dots in place and lift of the liner
- High tack removable = considered removable on most surface
- Low tack removable = temporary bond - easily removed from any surface
- Super High Tack = permanent bond on most surfaces
IMPORTANT - Leave 24 hours/overnight to assess the amount of fibre tear
ALWAYS USE A SEPARATE BRUSH FOR ADHESIVES AND RELEASE AGENTS
SHAKE WELL BEFORE USE. AVOID EXTREMES OF TEMPERATURE
PROTECT FROM FROST. WASH BRUSH IN CLEAN WATER
